Rose electronic CAT5 manual Applying power

Page 22

Applying power

Plug in the provided power adapters to a 110/220-volt source and to the power connector on the transmitter and receiver Unit. Only use the power adapter provided. GND and earth should not be connected. Mount ferrite rings in the DC lines to protect against electromagnetic interference. Boot up the connected CPU and wait for it to completely boot-up.

The two LEDs on each side of the CAT5 cable connector indicate the following:

Red LED, communication status

Off – no communication errors

Slow blinking – one or more communication errors occurred over a 60- minute period.

Fast blinking – Several communication errors occurred over a 60-minute period.

Green LED, Link status

On – power is on and link connection is locked.

Blinking – CAT5 cable not connected or damaged.

The two LEDs next to the power connector indicate the following:

Both LEDs on – system booted correctly.

Only one LED on – unknown video mode being used.

	18		CRYSTALVIEW PRO CAT5 INSTALLATION AND OPERATIONS MANUAL

Image 22

Contents Houston, Texas 10707 Stancliff RoadPhone 281 INSTALLATION AND OPERATIONS MANUALLIMITED WARRANTY CE DECLARATION OF CONFORMITY FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADARADIO-FREQUENCY INTERFERENCE STATEMENTS FCC/IC STATEMENTS, EU DECLARATION OF CONFORMITYFigures TABLE OF CONTENTSContents TablesDisclaimer INTRODUCTIONSystem introduction Features CompatibilityPackage contents DVI or VGAMODELS Receiver Transmitter Local KVM access Transmitter No local KVM accessConnectors PC modelRack model CrystalView Pro CAT5 cables CrystalView Pro CAT5 to Rose switch cableCABLES Transmitter unit to CPU cableON-SCREEN DISPLAY OSD Device Control - OSDSelect graphic source menu The brightness / contrast menu enables you to adjust Figure 5. Color / Color temp menu Figure 6. Image menu Figure 7. Tools menu Manually adjust the OSD No auto-detection of pixels and phase INSTALLATION InstallationMaximum distance Transmitter to Receiver cablingCable type CAT-5SET-UP instructions Mixed DVI and VGA Pixel clock set correctly Applying power Operating instructions Operating instructions - Local KVM accessOPERATING INSTRUCTIONS Frame RatesPC boots with no error messages but keyboard does not work TROUBLESHOOTINGTroubleshooting Wrong or missing characters from those typedSmeared characters Maintenance and Repair SERVICEService Information Technical SupportSafety SAFETYSafety and EMC Regulatory Statements Grounding Safety informationServicing Appendix A. General specifications APPENDICESPart Number Appendix C. Firmware updatesAppendix B. Parts and cables DescriptionAppendix D. Rack mount instructions Appendix E. Rack mount illustrationPhone 281 10707 Stancliff RoadHouston, Texas