number. That mean it will direct call out by VoIP when you off hook the phone of this line.
Tone Config
This page defines the tones generated to the phone connected to the phone port. All lines use same tone parameters. After modify the tone parameters, you must save modify then Reboot to let the modified parameters work.
Parameter Description
Use the parameters to automatic detect cadence busy tone. When detected a voice cadence repeat over this parameters setting in sequence, the VoIP router will treat it like busy tone and disconnect automatically. Please do not set this parameter less than 5 to avoid unexpected erroneous disconnect.
You can set up to 15 tones set for detection and generation. For the generation, the first entry will be used. The call progress tones, ranging from 300 Hz to 2000 Hz, are defined for both generation and detection. Generation, however, can be defined from 1 Hz to 3980 Hz.
Maximum 15 tones can be defined.
Dial: Define the generated dial tone for phone set
Busy: Define the busy tone for generate & detect
Ring: Define the ring back tone for generate
Lower frequency for defined tone
Higher frequency for defined tone. Each tone can define two frequencies, if only one frequency needed, please leave High Frequency to 0.
T_ON_1,T_OFF_1, T_ON_2, The cadence pattern of up to four intervals for each
Minimum Cadence value is 30msec.
19