Peavey GTX owner manual Power Connections, Console Cooling

CENTURY SERIES GTX

Power Connections

The connections to and from the power supply vary depending on your specific configuration. Before setting up the console, always check to make sure the AC voltage marked on the power supply agrees with the local supply. Always connect the console to the power supply before switching on the power supply. Do not run the power supply if it is not connected to the console.

Multiple power supplies can be daisy-chained to provide fail- safe protection in the event of a supply failure. When two or more supplies are used, both power supplies run all the time. In the event of supply failure, the remaining power supply(s) will take over the entire load.

NOTE: Although both of the multi-pin connectors on the back of the power supply are labeled “POWER OUT”, it is neces- sary (and acceptable) to link two power supplies together as shown in the diagram below.

ADDITIONAL NOTE: The multi-conductor cable used for power supply-to-power supply connection is different than that used for a conventional power supply-to-console connection, and must be specified when the second power supply is ordered.

Ground Link

To Console

		POWER OUT	CAUTION
			RISK OF ELECTRIC SHOCK
2 1			DO NOT OPEN	CONSOLE	CHASSIS
			AVIS : RISQUE DE CHOC ÉLECTRIQUE—NE PAS OUVRIR	GROUND	GROUND
5 4 3			WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT		MAXIMUM AC IN:
7	6		EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.		XCVA04: 415 WATTS
			ATTENTION! POUR ÉVITER LE RISQUE D'INCENDIE OU DE CHOC	Model XCVA04	XCVA06: 825 WATTS
			ÉLECTRIQUE, NE PLACEZ PAS CET APPAREIL SOUS LA PLUIE OU Á
			L'HUMIDITÉ	± 20VS/N@ 4
Pin 1 +24V			Designed & manufactured in the USA by:	+ 24V @ 4
Pin 2 +20V
Pin 3	Analog	POWER OUT		+ 48V @ 1
Pin 4	Analog			+ 24V @ 6
Pin 5 Digital				± 20V @ 6
Pin 6 +48V			A division of Crest Audio Inc.	Model XCVA06
Pin 7	-20V		100 Eisenhower Dr.
			Paramus, New Jersey 07652 USA

Interface Cable

		POWER OUT	CAUTION
			RISK OF ELECTRIC SHOCK
2 1			DO NOT OPEN	CONSOLE	CHASSIS
			AVIS : RISQUE DE CHOC ÉLECTRIQUE—NE PAS OUVRIR	GROUND	GROUND
5 4 3			WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT		MAXIMUM AC IN:
7	6		EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.		XCVA04: 415 WATTS
			ATTENTION! POUR ÉVITER LE RISQUE D'INCENDIE OU DE CHOC	Model XCVA04	XCVA06: 825 WATTS
			ÉLECTRIQUE, NE PLACEZ PAS CET APPAREIL SOUS LA PLUIE OU Á
			L'HUMIDITÉ	± 20VS/N@ 4
Pin 1 +24V			Designed & manufactured in the USA by:	+ 24V @ 4
Pin 2 +20V
Pin 3	Analog	POWER OUT		+ 48V @ 1
Pin 4	Analog			+ 24V @ 6
Pin 5 Digital				± 20V @ 6
Pin 6 +48V			A division of Crest Audio Inc.	Model XCVA06
Pin 7	-20V		100 Eisenhower Dr.
			Paramus, New Jersey 07652 USA

To AC Mains

To AC Mains

Console Cooling

A cooling fan configuration is included in all GTx consoles. Two fans (one at each end of the console) draw air in through the sides of the chassis (under the sidebars). Air is distributed through the chassis via a “vortex pan”, then proceeds up through the console modules, where the heated air exits the console chassis.

Once the console is powered up, cooling fans remain on. A rear panel switch permits the fans to be set at low, medium or high speeds.

There are no filters to change or clean. As with any console, use in dusty/unclean environments should be avoided.

PAGE 7