Multi Media | Re:source |
SETUP Multi Media Module
Important advice
The basic settings for the MMM are made in Setup.
Select Media from the Source menu and press and hold the Setup key for approx 2 seconds. Then select the Source softkey. The following display appears:
The following description for the Setup makes the assumption that there is a functioning network with router available and operational.
There is no further explanation of the specialist terminology used in the individual chapters. You will find an extensive description of these in the previous chapter "Glossary
NETWORK TERMINOLOGY"
All settings that are needed to set the MMM up are done on a total of eleven Setup pages, whereby only the relevant pages are shown.
Setup pages that you don't need because of a setting you have made are hidden.
Example: Setup #6
Use DHCP? YES
By selecting YES the settings on #7 and #8 in the IP and DNS area respectively are automatically made by the MMM. These Setup pages therefore, are not shown. You switch directly from Setup #6 to Setup #9.
If you have any questions about the setup and configuration of your network or Internet access, please refer to your System administrator or an IT specialist of your choosing.
Input field in Setup [...] Whenever you can make a setting within an input field in the following chapters, the area that is to be changed appears in the display in two square brackets [...].
M51 Inputs at the M51 are made using the rotary knob. At the same time, the small red lamp (Jog) next to the rotary knob lights up.
M10 Inputs at the M10 are made through the display panels from the M230 or M233 service programs. In the case, you use the fields Jog ±.
12