M51 Installation, M10 Installation

Multi Media

Re:source

INSTALLATION

The Multi Media Module is equipped with the latest electronics and should be handled with care.

Before you install the card, the M51/ M10 must be switched off and separated from the power supply, by plugging the unit out.

M51 Installation

The MMM can be operated in slots 1 - 6. The only exception is Slot 7, next to the speaker connections, as this is reserved for the 5.1 Decoder module.

!For loading reasons, only one MMM should be installed in an M51.

M10 Installation .

The MMM can be operated in slots 1 - 8 or A 1 - 2. Slots A1 and A2 should only be fitted with second generation modules, like the MMM, that have the following symbol on them:

!Up to 4 MMMs can be installed in parallel in an M10.

Loosen the two screws with the TORX screwdriver supplied and remove the blanking plate.

Before removing the MMM module from its packaging, you should make sure that you are not statically charged. This could cause a damaging discharge of voltage when you touch the module. You should get rid of any static charge by touching an earthed metal object like a radiator, for example.

Remove the MMM from its packaging and feed it into its plug- in position. The two bars inside the M51/ M10 are the mechanical guides for you to use.

The lettering on the MMM plug-in card must be on top. Shortly before the plug-in card is fully locked into position in its slot, you will feel a mechanical resistance, caused by the bus board contact strip. Push the MMM fully in by applying pressure in the area of the two screw holes and fix the card in place with both screws.

All further steps for registering the new module are carried out automatically the next time you switch on.