Data Sheet: PoweretaTM iQP Series
nominal input, full load, and Ta = 40˚C using the Telcordia
Improper handling or cleaning processes can adversely affect the appearance, testability, and reliability of the power modules. Contact TDK Innoveta technical support for guidance regarding proper handling, cleaning, and soldering of TDK Innoveta’s power modules.
Input/Output Ripple and Noise Measurements:
Quality:
TDK Innoveta’s product development process incorporates advanced quality planning tools such as FMEA and Cpk analysis to ensure designs are robust and reliable. All products are assembled at ISO certified assembly plants.
Vs
Lin
C0
C1
++
Vin Vout
--
Cext
RLoad
Ground Plane
The input reflected ripple is measured with a current probe and oscilloscope. The ripple current is the current through a 12∝H differential mode inductor, Lin, with esr ≤ 10 mΩ, feeding a capacitor, C1, esr ≤ 700 mΩ @ 100kHz, across the module input voltage pins. The capacitor C1 across the input shall be at least one 220∝F/100V electrolytic capacitor along with two 1uF to 2.2uF/100V ceramic capacitors. Two 220∝F/100V electrolytic capacitors and two 2.2uF/100V ceramic capacitors are recommended. A 220∝F/100V capacitor for C0 is also recommended.
The output ripple measurement is made approximately 7 cm (2.75 in.) from the power module using an oscilloscope and BNC socket. The capacitor Cext is located about 5 cm (2 in.) from the power module; its value varies from code to code and is found on the electrical data page for the power module of interest under the ripple & noise voltage specification in the Notes & Conditions column.
℡ (877) | 14/15 | |
iQP 5V/50A Datasheet 8/3/2006 |
|