Data Sheet: PoweretaTM iQP Series
Thermal Management:
An important part of the overall system design process is thermal management; thermal design must be considered at all levels to ensure good reliability and lifetime of the final system. Superior thermal design and the ability to operate in severe application environments are key elements of a robust, reliable power module.
A finite amount of heat must be dissipated from the power module to the surrounding environment. This heat is transferred by the
The cross section of the airflow passage is rectangular with the spacing between the top of the module and a parallel facing PCB kept at a constant (0.5 in). The power module’s orientation with respect to the airflow direction can have a significant impact on the unit’s thermal performance.
Thermal Derating: For proper application of the power module in a given thermal environment, output current derating curves are provided as a design guideline in the
three modes of heat transfer: convection, conduction and radiation. While all three modes of heat transfer are present in every application, convection is the dominant mode of heat transfer in most applications. However, to ensure adequate cooling and proper operation, all three modes should be considered in a final system configuration.
The open frame design of the power module provides an air path to individual components. This air path improves convection cooling to the surrounding environment, which reduces areas of heat concentration and resulting hot spots.
Test Setup: The thermal performance data of the power module is based upon measurements obtained from a wind tunnel test with the setup shown in the wind tunnel figure. This thermal test setup replicates the typical thermal environments encountered in most modern electronic systems with distributed power architectures. The electronic equipment in networking, telecom,
Module
Centerline
76 (3.0)
AIRFLOW
Air Velocity and Ambient
Temperature
Measurement Location
Adjacent PCB
A |
|
| 12.7 |
|
| ||
I |
|
| (0.50) |
R |
|
| |
|
|
| |
F |
|
|
|
L |
|
|
|
O |
|
|
|
W |
|
|
|
|
|
|
|
|
|
|
|
Air Passage
Centerline
wireless, and advanced computer systems operates in similar environments and utilizes vertically mounted printed circuit boards (PCBs) or circuit cards in cabinet racks.
The power module is mounted on a 0.062 inch thick,
Wind Tunnel Test Setup Figure
Dimensions are in millimeters and (inches).
Thermal Performance section for the power module of interest. The module temperature should be measured in the final system configuration to ensure proper thermal management of the power module. For thermal performance verification, the module temperature should be measured at the component indicated in the thermal measurement location figure on the thermal
℡ (877) | 9/15 | |
iQP 5V/50A Datasheet 8/3/2006 |
|