TDK iEA Series manual 19/41

Data Sheet: Belleta® iEA Series –Single Output Eighth Brick

Thermal Performance:

iEA48020A033V-000 through -015: 3.3V, 20A Output
	25												25
(A)	20											(A)	20
Current	15		NC									Current	15		NC
Output			0.5 m/s (100 LFM)									Output			0.5 m/s (100 LFM)
			1.0 m/s (200 LFM)												1.0 m/s (200 LFM)
	10		2.0 m/s (400 LFM)										10
															2.0 m/s (400 LFM)
			3.0 m/s (600 LFM)												3.0 m/s (600 LFM)
			Tc, Thermal Limit												Tc, Thermal Limit
	5												5
	30	40	50	60	70	80	90	100	110	120	130		30	40	50	60	70	80	90	100	110	120	130
					Temperature (C)												Temperature (C)

iEA48020A033V-000 maximum output current vs. ambient temperature at nominal input voltage for airflow rates natural convection (60lfm) to 600lfm with airflow from pin 3 to pin 1.

iEA48020A033V-000 maximum output current vs. ambient temperature at nominal input voltage for airflow rates natural convection (60lfm) to 600lfm with airflow from pin 1 to pin 3.

Best orientation airflow

Thermal measurement location on PWB Cu

iEA48020A033V-000 thermal measurement location – top view

Both the thermal curves provided and the example given above are based upon measurements made in TDK Innoveta’s experimental test setup that is described in the Thermal Management section. Due to the large number of variables in system design, TDK Innoveta recommends that the user verify the module’s thermal performance in the end application. The critical component should be thermo coupled and monitored, and should not exceed the temperature limit specified in the derating curve above. It is critical that the thermocouple be mounted in a manner that gives direct thermal contact or significant measurement errors may result. TDK Innoveta can provide modules with a thermocouple pre-mounted to the critical component for system verification tests.

©2004 TDK Innoveta® Inc.		￿ (877) 498-0099
iEAFullDatasheet 032707 3/29/2007	Revision 2.0	19/41