Quantum Atlas II manual Scsi ID A3, A2, A1, A0, Delay Spin DS, CStagger Spin, Write Protect

Page 2

Atlas II

Jumper Settings

Termination Power (TP)

 

Enable termination power

TP jumper on

Disable termination power

TP jumper off

SCSI ID (A3, A2, A1, A0)

 

Set drive SCSI ID

See ID settings table below

Delay Spin (DS)

Enable spin delay

SP jumper off

Disable spin delay

SP jumper on

cStagger Spin

 

Enable spin stagger

SS jumper on

Disable spin stagger

SS jumper off

Write Protect

Enable Write Protection

Disable Write Protection

WP jumper on WP jumper off

Jumper Locations

The Atlas II disk drive has two locations where user configurable jumpers are found. The primary jumper block (Front option connector J3) for the Atlas II is found on the front edge of the disk drive printed circuit board. Using these jumper pins you can establish the various drive configuration options. The second option jumper block is used to set the Atlas II termination options. This jumper block is found on the printed circuit board at the rear of the drive and is near the SCSI cable connector.

2 of 8

Image 2
Contents Jumper Settings AtlasCStagger Spin Delay Spin DSScsi ID A3, A2, A1, A0 Write ProtectPin Secondary Option Connector Signal Scsi ID Settings Jumper Settings Jumper Locations Pin Drive ID