Atlas II
Jumper Settings
Pin | Signal | Pin | Signal |
|
|
|
|
1 | A3 | 2 | logic_gnd |
3 | A2 | 4 | logic_gnd |
5 | A1 | 6 | logic_gnd |
7 | A0 | 8 | logic_gnd |
9 | Key (blank) | 10 | Fault LED |
11 | Delay Spin | 12 | logic_gnd |
13 | Logic ground | 14 | Enable Active Termination |
15 | Spindle Sync | 16 | Spindle Sync |
17 | Busy Led | 18 | +5VDC out |
19 | Write Protect | 20 | logic_gnd |
21 | Stagger Spin | 22 | logic_gnd |
23 | Enable Narrow Mode | 24 | logic_gnd |
25 | Disable Sync Negotiation | 26 | logic_gnd |
27 | Disable SCSI Parity | 28 | logic_gnd |
29 | Disable Unit Attention | 30 | logic_gnd |
31 | Customize | 32 | logic_gnd |
Pin | Signal | Pin | Signal |
|
|
|
|
|
|
|
|
1 | A0 | 2 | Fault LED |
3 | A1 | 4 | logic_gnd |
5 | A2 | 6 | logic_gnd |
7 | A3 | 8 | Busy LED |
9 | Enable Termination | 10 | logic_gnd |
11 | +5VDC out | 12 | (reserved) |
Note: Enable Termination setting is not supported on the following differential drives:
Atlas II 2.2GB WD
Atlas II 4.5GB WD
7 of 8