DLT VS80 Tape Drive Installation and Operations Guide
3.2.4Completing the Installation
1.Secure all the SCSI cable connectors by tightening their screws until snug.
2.Make sure the power switch on the rear panel of the tabletop tape drive is in the OFF position. See Figure
3.Attach the female connector on the power cable to the power connector on the rear panel of the tape drive.
4.Plug in the power cable to a nearby power outlet.
5.Attach the power cables to the host server or workstation and all attached devices.
6.Power on the tabletop tape drive and any other devices you powered off earlier.
7.Power on the host server or workstation and allow its operating system to start.
8.Check your tape drive to make sure it is working properly. See “Testing Your Tape Drive” on page
May 2004 |