Quantum DLT VS80 manual Workstation Scsi Cable Connections

Page 21

DLT VS80 Tape Drive Installation and Operations Guide

5.Connect the other end of the SCSI cable to the connector on your SCSI host bus adapter, as shown in Figure 3-4or to the connector on the previous SCSI device on the SCSI bus.

Host bus adapter

SCSI cable

Figure 3-4.Workstation SCSI Cable Connections

NOTE: If the SCSI cable does not fit the connector on the SCSI host bus adapter, you either have an incompatible SCSI host bus adapter or you need to purchase a cable adapter. Contact Quantum Corporation or your SCSI host bus adapter manufacturer for information.

001596-01 Rev A07

May 2004

3-7

Image 21

Contents Page Trademarks CopyrightLegal Disclaimers Contact InformationFollowing table lists all revisions made to this document Revision HistoryMay Table of Contents DLT VS80 Use List of Figures List of Figures Viii May List of Tables List of Tables May Purpose and Scope Related DocumentsStructure of this Manual For More Information Reader Comments Conventions Used in this ManualDLT VS80 Tape Drive Features DLT VS80 Tape Drive OverviewData Transfer Rate Embedded Diagnostics Firmware Update CapabilityCapacity Data CompressionScsi Requirements Preparing to Install Your Tape DriveBefore You Begin Installing Your Tabletop Tape DriveUnpacking Your Tabletop Tape Drive and Selecting a Location Unpacking Your Tabletop Tape DriveSelecting a Location for Your Tabletop Tape Drive Tabletop Tape Drive Rear Panel Layout Setting the Scsi IDScsi ID Selector Switch Connecting the CablesTape Drive Scsi and Power Cable Connections Workstation Scsi Cable Connections Terminating Your Tabletop Tape Drive Powering the TerminatorCompleting the Installation Unpacking Your Internal Tape Drive Installing Your Internal Tape DriveSetting the Scsi ID Configuring Your Internal Tape DriveTerminating Your Internal Tape Drive Terminator InstallationScsi Cable with Built-in Terminator Installing Your Internal Tape DriveDLT VS80 Installation 10.Tape Drive Installation in an Open Drive Bay Refer to Terminating Your Internal Tape Drive on 12.Securing the Internal Tape Drive in the Installation Bay Testing Your Tape Drive Troubleshooting Your Tape Drive General Troubleshooting GuidelinesTroubleshooting the Tape Drive Symptom Problem Solution Understanding Errors Indicated by Front Panel LEDs DLT VS80 Installation May DLT VS80 Use Front Panel Controls and IndicatorsIndicator Activity During Tape Drive Operation Indicator Activity During Power-On Self-Test PostLEDs on page 3-20for help troubleshooting your tape drive Loading a Data Cartridge Data Cartridge Use and CareUnloading a Data Cartridge Write-Protecting Data Cartridges Caring for Your Data Cartridges Using the Cleaning Cartridge Updating Tape Drive Firmware-Overview DLT VS80 FirmwareCreating a Firmware Update Data Cartridge Updating the FirmwareUpdating the Firmware DLT VS80 Tape Drive Installation and Operations Guide Problem Indications/Solution Troubleshooting the Firmware UpgradePage Rev A07