Chapter 2: Installation
NIC2 (LAN2) LED
The LED connections for LAN2 are on pins 9 and 10 of JF1. Attach LAN LED cables to display network activity. See the table on the right for pin definitions.
NIC1 (LAN1) LED
The LED connections for LAN1 are on pins 11 and 12 of JF1. Attach LAN LED cables to display network activity. See the table on the right for pin definitions.
HDD LED
The HDD LED connection is located on pins 13 and 14 of JF1. Attach the hard drive LED cable here to display disk activity (for any hard drives on the system, including SAS, Serial ATA and IDE). See the table on the right for pin definitions
Power On LED
The Power On LED connector is located on pins 15 and 16 of JF1. This connection is used to provide LED indication of power being supplied to the system. See the table on the right for pin definitions.
NMI Button
The
LAN1/2 (Ethernet Ports)
Two Gigabit Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port. Additionally, there is a dedicated LAN poor for IPMI beside the two rear USB ports. These Ethernet ports accept RJ45 type cables.
NIC2 LED
Pin Definitions
(JF1)
Pin# Definition
9Vcc
10Ground
NIC1 LED
Pin Definitions
(JF1)
Pin# Definition
11Vcc
12Ground
HDD LED
Pin Definitions
(JF1)
Pin# Definition
13Vcc
14HD Active
Power LED
Pin Definitions
(JF1)
Pin# Definition
155V Stby
16Control
NMI Button
Pin Definitions
(JF1)
Pin# Definition
19Control
20Ground