SUPER MICRO Computer H8QII-F No Video, Memory Errors, Losing the System’s Setup Configuration

H8QI6/i-F Serverboard User's Manual

4.Turn the power switch on and off to test the system.

5.The battery on your motherboard may be old. Check to verify that it still sup- plies ~3VDC. If it does not, replace it with a new one.

No Video

1.If the power is on but you have no video, remove all the add-on cards and cables.

2.Use the speaker to determine if any beep codes exist. Refer to Appendix A for details on beep codes.

NOTE

If you are a system integrator, VAR or OEM, a POST diagnostics card is recommended. For I/O port 80h codes, refer to App. B.

Memory Errors

1.Make sure that the DIMM modules are properly and fully installed.

2.You should be using registered ECC DDR-2 memory (see next page). Also, it is recommended that you use the same memory type and speed for all DIMMs in the system. See Section 2-4 for memory details.

3.Check for bad DIMM modules or slots by swapping modules between slots and noting the results.

4.Check the power supply voltage 115V/230V switch.

Losing the System’s Setup Configuration

1.Make sure that you are using a high quality power supply. A poor quality power supply may cause the system to lose the CMOS setup information. Refer to Section 1-6 for details on recommended power supplies.

2.The battery on your motherboard may be old. Check to verify that it still sup- plies ~3VDC. If it does not, replace it with a new one.

3.If the above steps do not fix the setup configuration problem, contact your vendor for repairs.

3-2