SMC Networks SMCWCB-N2 manual Hardware and Wireless Utility Installation

Page 17

Hardware and Wireless Utility Installation

Follow the instructions below to install the Cardbus Adapter and Wireless Utility.

Do not insert the EZ Connect™ N Wireless Cardbus Adapter until instructed.

1.Put the EZ Installation & Documentation CD in to your CD-ROM drive. The CD will auto run. If the CD does not auto run browse to your CD drive & double-click the “SMCWCB_N2.exe” file.

2.Click [Install Driver/Utility] to start the installation Wizard.

3.The installation Wizard will run. Click [Next] to continue.

4.To install to the default folder location click [Next]. It is recommended to use the default folder location unless you are an advanced user. To change the installation folder click the [Browse] button and specify a new location. Click [Next] to continue.

14

Image 17

Contents SMCWCB-N2 Limited Warranty Page FCC Radiation Exposure Statement Important NoteCompliances Europe EU Declaration of Conformity 0560ΜΕ ΤΗΝ Παρουσα SMC Networks ∆ΗΛΩΝΕΙ ΟΤΙ Radio LAN device CompliancesPage Table of Contents Getting Started with the SMCWCB-N2 Transmission Rate Transfer Rate Types of Wireless NetworksAD-HOCIBSS Network Page Page Roaming in an ESS network diagram Wireless LAN Security Package Content About Your Draft 11n Wireless Cardbus AdapterSystem Requirement LED DefinitionHardware and Wireless Utility Installation Page Page Using the Utility to Configure Your Network Page Infrastructure access point Ad Hoc Wireless Network StatusTCP/IP Status ChannelSecurity Status Profile Connecting to a different networkScan Available Networks Bits WEP WPA/WPA2802.1x Advanced SettingsLong Short Auto Power Save ModeWPS WPS Setup PBC Push-button ConfigurationPage WPS Setup PIN Configuration WPS Status Bar Description Upgrading the Wireless Utility Uninstall the DriverUninstall the Client Utility Glossary Ssid SMCWCB-N2 SMCWBR11-G