SMC Networks SMCWUSBS-N manual WPS Setup PIN Configuration

Wireless Utility Configuration

-Registrar – A registrar is the network enrollment center.

If the Wireless USB Adapter is set as a registrar, click the Rescan button on the utility WPS setup page to search for WPS-enabled wireless devices near you. All enrollees found will be displayed in the WPS Profile List. Select an enrollee on the list and click the Connect button to activate the connection.

3.Press the physical button on the Wireless USB Adapter or click PBC button on this utility page to start to establish a wireless connection (this may require several seconds to one minute to complete).

Notes: 1. If WPS fails, click the PBC button few more times to try again.

2.When an access point or a WPS enrollee is connected, you can click Disconnect to disconnect from the connected device, or select another WPS-enabled wireless access point or enrollee, then click Connect to establish connection.

3.You can also click the Rotate button to select the next access point or enrollee in the list and establish a connection.

4.To delete an access point from the list, click Delete.

WPS Setup - PIN Configuration

The WPS PIN (Personal Identification Number) setup is optional to the WPS button setup. It is more secure than using the WPS button. All WPS-compatible devices have their own PIN number.

1.When the Wireless USB Adapter is set as an enrollee, the PIN number of your Wireless USB Adapter is an eight-digit number located at the upper-right position of configuration utility. Remember this number and input it to your wireless access point as the WPS PIN code. Please also refer to the user manual of your wireless access point for instructions about WPS setup.

Click PIN button and wait for few seconds to one minute. If a wireless access point with correct PIN code is found, you will be connected to that access point.

Note: You may have to click PIN for few more times to try again. If you still cannot connect to an access point this way, please make sure the PIN code you provided to access point is correct.

2.When the Wireless USB Adapter is set as a registrar, input the enrollee’s PIN number to the Pin Code box located in the upper-right position of configuration utility.

Click PIN button and wait for few seconds to one minute. If a WPS enrollee with correct PIN code is found, it will be connected to the Wireless USB Adapter.

3-15