Onkyo TX-SR707 instruction manual Basic Operations—Continued, Adjusting the Bass & Treble

Basic Operations—Continued

–, +, TONE DIMMER

DISPLAY

DISPLAY

Press [RECEIVER]

first. MUTING

SP LAYOUT

DIMMER SLEEP

Adjusting the Bass & Treble

You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected.

1		Press the [TONE] button repeat-
	AV receiver	edly to select either “Bass” or
		“Treble”.

2	Use the TONE [–]/[+] buttons to
	adjust.
	AV receiver

Tip:

This procedure can also be performed on the remote controller by using [AUDIO] button (see page 99).

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

Note:

To bypass the bass and treble tone circuits, select the Direct, Pure Audio or THX listening mode.

Displaying Source Information

You can display various information about the current input source as follows.

Remote	Press the [RECEIVER] button,
controller	and then press the [DISPLAY]
	button repeatedly to cycle
	through the available informa-
	tion.

Note:

This procedure can also be performed on the AV receiver by using its [DISPLAY] button.

The following information can typically be displayed for input sources.

Input source Listening

mode

Signal format* Sampling frequency

Input Signal

Resolution

Output

Resolution

*If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format and the number of channels is displayed. For some digital input sig- nals, including multichannel PCM, the signal format, number of channels, and sampling frequency is displayed.

Information is displayed for about three seconds, then the previ- ously displayed information reappears.

Setting the Display Brightness

You can adjust the brightness of the AV receiver’s dis- play.

Remote	Press the [RECEIVER] button,
controller	and then press the [DIMMER]
	button repeatedly to select: dim,
	dimmer, or normal brightness.
	Alternatively, you can use the AV
	receiver’s [DIMMER] button (North
	American and Taiwan models).

57