Onkyo TX-SR707 100, Re-EQ Function, Audyssey Dynamic Volume, Music Optimizer, Speaker Levels

Advanced Setup—Continued

Re-EQ Function

With the Re-EQ function, you can compensate a soundtrack whose high-frequency content is too harsh, making it more suitable for home theater viewing.

Re-EQ	Off: Re-EQ Function off (default).
	On: Re-EQ Function on.

This function can be used with the following listening modes: Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Multichannel, DTS, DTS-HD High Resolution Audio, DTS-HD Master Audio, DTS Express, DSD, Dolby EX, Dolby Pro Logic IIz Height, Dolby PLIIx Movie, Neo:6 Cinema, and 5.1-channel source + Neo:6.

Re-EQ(THX)	Off: Re-EQ (THX) Function off.
	On: Re-EQ (THX) Function on (default).

This function can be used with the following listening modes: THX Cinema, THX Surround EX, and THX Select2 Cinema.

Note:

Settings for the Re-EQ function are kept in each listening mode. However, in THX listening mode, when the AV receiver is turned off, it will return to “On”.

Audyssey Dynamic Volume™

Dynamic Volume See “Dynamic Volume” of “Audio Adjust” on page 86.

Note:

If you would like to use Audyssey Dynamic Volume™, when using THX listening modes, set “Loudness Plus” setting to “Off” and set “Preserve THX Settings” setting to “No”.

Music Optimizer

The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that use “lossy” compression, such as MP3. The setting is stored individually for each input selector.

Music Optimizer	Off:	Music Optimizer off (default).
	On:	Music Optimizer on.

Note:

The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48 kHz and analog audio input signals. The Music Optimizer is disabled when the Direct or Pure Audio listen- ing mode is selected.

Speaker Levels

You can adjust the volume of each speaker while listening to an input source.

These temporary adjustments are cancelled when the AV receiver is set to Standby. To save the setting you made here, go to “Level Calibration” on page 82 before setting the AV receiver to Standby.

Subwoofer	–15.0 dB to +12.0 dB (default: 0.0 dB)
Center	–12.0 dB to +12.0 dB (default: 0.0 dB)

Notes:

•You cannot use this function while the AV receiver is muted.

•Speakers that are set to “No” or “None” in the “Speaker Configuration” cannot be adjusted (see page 80).

•This function will not work when the Pure Audio or Direct listening mode is selected to play analog audio.

100