Onkyo TX-SR707 Using Zone, Controlling Zone 2 from the AV receiver, Zone 2—Continued, models

Zone 2—Continued

Using Zone 2

This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2.

Controlling Zone 2 from the AV receiver

ZONE 2 OFF

ZONE 2 indicator Input selector buttons

1	To turn on Zone 2 and select an
	input source, press the [ZONE 2]
	button followed by an input
	selector button within 8 seconds.
	Zone 2 turns on, the ZONE 2 indicator
	lights up.
	Tip :
	The 12V TRIGGER OUT ZONE 2
	goes high (+12 V).
	To select AM or FM press the
	[TUNER] input selector and the
	[ZONE 2] button repeatedly. You can
	also select SIRIUS (North American
	models).
	To select the same source as that of the
	main room, press the [ZONE 2] button
	twice. “Zone 2 Selector: Source”
2	appears on the display.
	To turn off Zone 2, press the
	[ZONE 2] button.

The ZONE 2 indicator flashes.

Press the [OFF] button.

The zone is turned off, and the ZONE 2 indicator goes off.

Note:

When Zone 2 is turned off, the output from the 12V TRIGGER OUT ZONE 2 goes low (0 volts).

Controlling Zone 2 with the Remote Controller

STANDBY
ON	ZONE2
INPUT
SELECTOR

Note:

To control Zone 2, you must press the remote control- ler’s [ZONE2] button first.

The ZONE2 button turns red while Zone 2 is on.

1	Press the [ZONE2] button, then
	point the remote controller at the
	AV receiver and press the [ON]
	button.
	Tip :
	The 12V TRIGGER OUT ZONE 2

goes high (+12 V).

2	To select an input source for
	Zone 2, press the [ZONE2]
	button, followed by an INPUT
	SELECTOR button.
	To select AM or FM press the
	[TUNER] INPUT SELECTOR and the
	[ZONE2] button repeatedly. You can
	also select SIRIUS (North American
	models).

3	To turn off Zone 2, press the
	[ZONE2] button, followed by the
	[STANDBY] button.

105