Onkyo TX-SR707 Error Messages, First Time Setup—Continued, The options are, Save, setup, Cancel

First Time Setup—Continued

9	When the calculations are com-
	plete, the following screen
	appears.
	MultEQ: Auto Setup
	-- Review SP Configuration --
	Subwoofer	No
	Front	Full Band
	Center	40Hz
	Surround	120Hz
	Front Wide	Full Band
	Front High	Full Band
	Surr Back	150Hz
	Surr Back Ch	2ch
	Save
	Cancel
	Use the Up and Down [q]/[w] but-
	tons to select an option, and then
	press [ENTER].
	The options are:
	Save:
	Save the calculated settings and exit
	the room correction and speaker
	setup.
	Cancel:
	Cancel the room correction and
	speaker setup.
	Note:
	You can view the calculated settings for
	the speaker configuration, speaker dis-
	tances, and speaker levels by using the
	Left and Right [e]/[r] buttons.
10	If you selected “Save”, the results are
	saved, and the following screen
	appears.
	MultEQ: Auto Setup
		Saving...

11	Disconnect the speaker setup
	microphone.
		MultEQ: Auto Setup
		Please, unplug setup microphone.

Notes:

•When the room correction and speaker setup is complete, the “Equalizer Settings” (page 82) will be

set to “Audyssey” and the “Dynamic EQ” (page 86) will be set to “On”.

•You can cancel the Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.

Error Messages

While the room correction and speaker setup is in progress, one of the following error messages may appear:

❏Ambient noise is too high.

MultEQ: Auto Setup

Ambient noise is too high.

Retry

Cancel

This message appears if the background noise is too loud and the measurements cannot be performed properly.

Remove the source of the noise and try again.

Retry: Return to the measured point immediately before and start set up again.

Cancel: Cancel the room correction and speaker setup.

❏Speaker Detect Error

This message appears if a speaker is not detected. “Yes” means that a speaker was detected. “No” means that no speaker was detected.

MultEQ: Auto Setup

Speaker Detect Error

FL	:	No	FR	:	---
SL	:	---	SR	:	---
FWL :		---	FWR :		---
FHL	:	---	FHR	:	---
SBL	:	---	SBR	:	---
C	:	---	SW	:	---

Retry

Cancel

The front speaker has not been detected.

MultEQ: Auto Setup

Speaker Detect Error

FL	:	Yes	FR	:	No
SL	:	---	SR	:	---
FWL :		Yes	FWR :		Yes
FHL	:	Yes	FHR :		Yes
SBL	:	---	SBR	:	---
C	:	Yes	SW	:	---

Retry

Cancel

One of the front speakers has not been detected.

53