Onkyo TX-SR707 Adjusting the Volume for Zone, Muting Zones, Zone 2—Continued, Notes

Zone 2—Continued

Notes:

•Only analog input sources are output by the ZONE 2 LINE OUT and ZONE 2 L/R speaker terminals. Dig- ital input sources are not output. If no sound is heard when an input source is selected, check if it’s con- nected to an analog input.

•You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that sta- tion will also be used in Zone 2.

•When you connect Zone 2 speakers directly to the AV receiver, listening modes that require surround back speakers or front high speakers or front wide speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz height, and Audyssey Dynamic Surround Expansion™ are unavailable.

•When the input selector of Zone 2 is selected, power consumption on standby mode slightly increases.

•While Zone 2 is on, ufunctions will not work.

Adjusting the Volume for Zone 2

Remote	On the remote controller, press
controller	the [ZONE2] button, and then use
	the VOL [q]/[w] button.

AV receiver On the AV receiver, press the [ZONE 2] button (the ZONE 2

indicator and Zone 2 selector on

the display flashes) and use the [–]/[+] buttons within 8 seconds.

Note:

You can adjust the volume only when Powered Zone 2 is being used.

Muting Zones

Remote	On the remote controller, press
controller	the [ZONE2] button, and then
	press the [MUTING] button.

To unmute a zone, on the remote controller, press the [ZONE2] button, and then press the [MUTING] button again.

Note:

Zones can also be unmuted by adjusting the volume.

106