Preparation for Installation
Always double check for any missing parts from the kit you received before deployment.
Next step is to set up the computer Ethernet interface for configuring the TT™5800X/TT™2400X. you’ll need to set the computer Ethernet interface within the same IP range as your TT™5800X/TT™2400X.
Check the following section - “Hardware Installation” and the next chapter - “Configuring Windows for IP Networking” to obtain complete details.
Hardware Installation
Follow the procedure below to install your TT™5800X/TT™2400X device:
1.Select a suitable place on the network to install the TT™5800X/TT™2400X. For best wireless reception and performance the external antenna should be positioned within Line of Sight from the AP with proper alignment.
2.Connect the TT™5800X/TT™2400X to the ODU side of the PoE Injector, via a straight Ethernet cable
3.Connect the 48VDC power adapter to the power jack on the PoE injector to power on the TT™5800X/TT™2400X.
4.Check the LEDs on the TT™5800X/TT™2400X to confirm if the status is okay. At this point the Power LED should be on in Red and Ethernet should be on in Green. The RF light should light up once the unit is associated wirelessly with another wireless device. However at this point the unit is still in factory default setting so do not alarm if the RF light doesn’t light up.
5.Now the hardware installation is complete, and you may proceed to the next chapter
Configuring Windows for IP Networking
All Rights Reserved. Copyright 2006 Teletronics International, Inc.
2 Choke Cherry Road, Rockville, MD 20850 Tel: 301.309.8500 Fax: 301.309.8851