SMC Networks Barricade specifications Appendix B TCP/IP Configuration for Windows 95/98

Page 31

Appendix B: TCP/IP Configuration for Windows 95/98

This section will show you how to install the TCP/IP protocol into your personal computer. If you are unfamiliar with it, please refer to your network card manual. Also, Section B.2 shows you how to set TCP/IP values to operate the Barricade correctly.

B.1 Installing TCP/IP protocol into your PC

1.Click the Start button and choose Settings, then click Control Panel.

2.Double click the Network icon and select the Configuration tab in the Network window.

3.Click the Add button to add the network component into your PC.

4.Double click Protocol to add TCP/IP protocol.

-30-

Image 31

Contents User Guide Trademarks Table of Contents Page Introduction Functions and FeaturesVirtual Server supported Packing ListPanel Layout Hardware InstallationTop Panel Installation RequirementsProcedure for Hardware Installation Power on Setting your computer network settings properly Network Settings and Software InstallationRequest timed out Install the Software into Your ComputersPage Page Startup and Log Configuring the BarricadeStatus Toolbox Primary Setup Static IP Address Dhcp Server Dhcp Server Choose Disable or EnableVirtual Server Virtual server mapping table Service Port Server IP Enable Special AP Access Control Miscellaneous Items Print Server Configuring on Windows 95/98 PlatformsPage Configuring on Windows NT Platforms Configuring on Unix based Platforms Appendix a Console Mode Installing TCP/IP protocol into your PC Appendix B TCP/IP Configuration for Windows 95/98Setting TCP/IP protocol to work with the Barricade Page Don’t input any values in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page Page That’s it. You are now ready to start using your Barricade @Home Appendix C Installation Guide For Specific ISPMediaOne