Xantech D5KP Auxiliary Power Connector AUX Power OUT D5RH and D5SH, D5SH4

Page 13

Auxiliary Power Connector (AUX POWER OUT) – D5RH and D5SH, D5SH4

For wire runs over 150’, it is recommended to run an additional 16 AWG/2-conductor wire from the head-end location to the Amplified Keypad locations. This will allow the AUX POWER OUT terminals to supply additional power to the Amplifier Keypads to compensate for the additional distance. For wire runs over 300’, 16 AWG/2 conductor wire is required. The maximum wire run using CAT-5 and 16 AWG/2-conductor is 600’. Make all connections between the D5RH and the D5KP Amplifier Keypad as previously described, then make the aux power connections described below.

To make connections:

1Ensure that system power is OFF!

2Strip the ends of the 16 AWG wire 1/4" on both ends of the wire run.

3Remove the terminal strip from the AUX POWER OUT connector on the D5RH or D5SH, D5SH4.

4Loosen the screws for the appropriate zone’s terminal pairs on the terminal strip.

5Insert the wires into the terminal strip, paying close attention to polarity (+/-).

6Tighten the screws on the terminal strip.

7Remove the terminal strip from the PWR IN connector of the D5KP.

8Loosen the screws on the D5KP’s PWR IN terminal.

9Insert the wires into the terminal, paying close attention to polarity (+/-).

10Tighten the screws on the D5KP’s PWR IN terminal.

11Connect the terminal strip back onto the AUX POWER OUT connector on the D5RH or D5SH, D5SH4.

Figure 3.1: AUX POWER OUT Connections on D5SH and D5RH

- 13 -

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Installation Instructions Safety Information Important Safety InformationOperating Temperatures & Environments D5KP Accessories FeaturesIntroduction Exceptional PerformanceSystem Design Overview/Applications Defining TermsD5KP Amplifier Keypad to Speakers Pre-WiringD5IP Local Sources to the D5KP Amplifier Keypad D5KP Front D5KP Rear D5KP Keypad Installation InstallationZone OUT D5RH ConnectionsZone OUT D5SH, D5SH4 Auxiliary Power Connector AUX Power OUT D5RH and D5SH, D5SH4 External IR Receiver Connections D5IP Source Input Wall PlateDescription Internal IR ReceiverSpeaker Connections D5KP Speaker ConnectionsD5KP Installer Setup User Parameters Do not Disturb DND Whole House Music WHMSetup Parameters External IR Enable IR EXT Internal IR Enable IR INTLocal Source LOCK-OUT Locl DET Source LOCK-OUT SRC LCKSymptom Possible Cause Solution TroubleshootingXantech Limited Warranty Specifications
Top Page Image Contents