D5IP Source Input Wall Plate
Interconnecting between the D5KP and the D5IP Source Input Plate consists of plugging in a CAT-5 cable terminated to an RJ-45 connector wired to T-568A standard (see Figure 2.0) to the RJ-45 jack on the rear of the D5IP. The other end simply plugs into the LOCAL PORT RJ-45 jack on the rear of the zone’s D5KP Amplified Keypad. See Figure 3.2 for details.
Cat-5
L+ L- R+ R- | - + |
SPEAKERS | PWR IN |
| Figure 3.2: D5IP to D5KP Connections |
External IR Receiver Connections
Use a standard IR Receiver such as Xantech’s 291D Series in areas where a hand-held remote needs to be pointed somewhere other than at the D5KP. Typical IR Receiver locations are near a TV or other equipment such as a Local Source (DVD Player, CD Player, A/V Receiver, etc.). Use a CAT-5 wire to extend the IR Receiver’s cable if necessary and connect the other end to the D5KP. Only three conductors of the CAT-5 will be used. By default, the D5KP External and Internal IR is active. To disable the External or Internal IR, see Section 4.0.
291D SERIES
Internal Wire Colors
White IR OUT
Black GND
Red +12V
D5KP
Figure 3.3: D5KP to External IR Connections
- 14 -
