Seagate ST32550W/WD/WC/DC, ST31250W/WD/WC/DC, ST31250N/ND manual Drive models, General information

Page 21

Barracuda 2LP Installation Guide, Rev. E

19

Initial setup information

The general information beginning on this page applies to all of the Barracuda 2LP drive models. After reading the general information topics, refer to the appropriate drive- specific section listed below for additional information about configuring and installing your particular model.

Drive models

 

Page

ST31250N

ST31250ND

33

ST32550N

ST32550ND

 

ST31250W

ST31250WD

38

ST32550W

ST32550WD

 

ST31250WC

ST31250DC

44

ST32550WC

ST32550DC

 

General information

The following general information topics are discussed:

SCSI ID jumpers

Drive termination

Synchronizing spindles

Other applicable jumper options

Providing adequate cooling

Mounting the drive and connecting cables*

Formatting the drive

Image 21
Contents Barracuda 2LP Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Barracuda 2LP Installation Guide, Rev. E Wichtige Sicherheitshinweise Barracuda 2LP Installation Guide, Rev. E Page Barracuda 2LP Installation Guide, Rev. E Page CompuServe Forum SeaFAX USA 408 438-2620 EnglandSeaFONE 408 SeaTDD 408SeaBOARD Location Modem number General description Characteristics ST31250 ST32550 Barracuda 2LP Installation Guide, Rev. E Amps Barracuda 2LP Installation Guide, Rev. E Barracuda 2LP Installation Guide, Rev. E General information Drive modelsScsi ID jumpers Scsi bus termination Drive terminationSynchronizing spindles Terminator powerProviding adequate cooling Kühlung des Systems Suggested air flow Abbildung 3. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der Kabel Barracuda 2LP Installation Guide, Rev. E DC power connector Abbildung 4. Gleichstromanschluß Hinweis Formatting the drive Enabling write cache Setting the Scsi ID Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Spindle sync connectors Several other jumper options are available as illustrated Other applicable jumper optionsWD drives Terminating the drive ST32550W shown Term. power to Scsi bus default Scsi I/O Other option jumpers are available as illustrated below Scsi ID = WC/DC drives Option jumpers are available as illustrated below Applicable jumper optionsPin J4 Pin 1 front view of J4 Page Page