Seagate ST31250N/ND, ST31250W/WD/WC/DC, ST32550W/WD/WC/DC, ST32550N/ND manual WC/DC drives

Page 46

44Barracuda 2LP Installation Guide, Rev. E

WC/DC drives

Setting the SCSI ID jumpers

The SCSI ID for WC drives is normally set over the SCSI bus by the host system using connector contacts 39 (ID0), 40 (ID2), 79 (ID1), and 80 (ID3). Systems design- ers may, optionally, install a remote operator panel con- nection to set the SCSI ID. Figure 15b illustrates the SCSI ID pins used for this purpose.

Terminating the drive

ST31250WC and ST32550WC drives do not have inter- nal terminators or any other way of adding internal termination to the drive. You must provide single-ended external active termination (ANSI SCSI-2 Alternative 2) to these drives when termination is required.

Synchronizing spindles

Spindle synchronization for WC drives is normally handled on the SCSI bus by the host system using connector contact 37 for the spindle sync reference signal. System designers may, optionally, install a spindle sync cable using pin 6 on the J4 connector to provide +SSREF (see Figure 15b).

Image 46

Contents Barracuda 2LP Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page Barracuda 2LP Installation Guide, Rev. E Wichtige Sicherheitshinweise Barracuda 2LP Installation Guide, Rev. E Page Barracuda 2LP Installation Guide, Rev. E Page SeaFAX USA 408 438-2620 England CompuServe ForumSeaTDD 408 SeaFONE 408SeaBOARD Location Modem number General description Characteristics ST31250 ST32550 Barracuda 2LP Installation Guide, Rev. E Amps Barracuda 2LP Installation Guide, Rev. E Barracuda 2LP Installation Guide, Rev. E Drive models General informationScsi ID jumpers Drive termination Scsi bus terminationTerminator power Synchronizing spindlesProviding adequate cooling Kühlung des Systems Suggested air flow Abbildung 3. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der Kabel Barracuda 2LP Installation Guide, Rev. E DC power connector Abbildung 4. Gleichstromanschluß Hinweis Formatting the drive Enabling write cache Setting the Scsi ID jumpers Setting the Scsi IDTerminating the drive Terminating the driveSetting terminator power jumpers Spindle sync connectors Other applicable jumper options Several other jumper options are available as illustratedWD drives Terminating the drive ST32550W shown Term. power to Scsi bus default Scsi I/O Other option jumpers are available as illustrated below Scsi ID = WC/DC drives Applicable jumper options Option jumpers are available as illustrated belowPin J4 Pin 1 front view of J4 Page Page