38Barracuda 2LP Installation Guide, Rev. E
W/WD drives
Setting the SCSI ID jumpers
Use the J5 connector to set the SCSI ID (Figure 10). To change the SCSI ID, install jumpers on the appropriate pins as shown in the illustration.
SCSI I/O |
| DC Power |
|
Connector Pin 1 | Pin 1 |
| |
Connector |
| ||
| J5 |
| |
|
|
| |
| 4P | 3P 2P | 1P |
ID3 ID1
ID2 ID0
J5 
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15