Seagate ST136475LW/LC manual Drive models, General information

Page 21

Barracuda 36 Installation Guide, Rev. B

19

Initial setup information

The general information beginning on this page applies to all of the Barracuda 36 drive models. After reading the general infor- mation topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models	Page
ST136475LW	39
ST136475LC	44

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “LC” model drives. To mount an “LC” drive, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.

Image 21

Contents Barracuda Disc Drive ST136475LW/LC Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Barracuda 36 Installation Guide, Rev. B Regulatory agency compliance Electromagnetic susceptibilityElectromagnetic compliance Australian C-Tick Electromagnetic compliance for the European UnionSeagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services SeaFAX General description RPM Drive characteristicsST136475LW/LC DC power requirements Amps, multimodeDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerPage Cable characteristics for single-ended I/O Circuits Cable characteristics for differential I/O circuits Sixty-eight pin connection to drive Multiple-drive connection to host adapter Drive model LC with single 80-pin I/O and power connector Providing adequate cooling Kü hlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Installation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage DC power connector Abbildung 5. Gleichstromanschluß Hinweis Barracuda 36 Installation Guide, Rev. B Mounting configuration dimensions Quick reference desktop system notes Formatting the driveTerminating the drive Setting the Scsi ID jumpersSetting the Scsi ID on model LW drives Host Alternate Additional jumper options for LW drives Other applicable jumper optionsAdditional jumper option for LW drives LC drives Jumper options for LC drives Single-ended/low-voltage-differential selection Additional jumper option for LC drives Page