Seagate ST136475LW/LC manual Mounting configuration dimensions

Barracuda 36 Installation Guide, Rev. B		37
C
[3]	G
[1]	D
E	F
	A
	Notes:

B

J [4] L

K

[2]

M [6]

J2

[6] N

H

S [8]

J6LED

P [5]

R

[1]Mounting holes three on each side, 6-32 UNC. Max screw length into side of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0 in-lb (.675 NM) max with minimum thread engagement of 0.12 in. (3.05 mm).

[2]Mounting holes four on bottom, 6-32 UNC. Max screw length into bottom of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0 in-lb (.675 NM) max with minimum thread engagement of 0.12 in. (3.05 mm).

[3]Power and interface connectors can extend past the “A” dimension by 0.040 in. (1.02 mm).

[4]Centerline of pad for Pin 1 of power connector.

[5]Centerline of pad for Pin 1 of J6.

[6]Centerline of pad for Pin 1 of J2. Dimensions indicated are for reference only.

[7]Dimensions to Pin 1 of each connector are nominal values.

[8]To pin ends on J6. Pin ends on J6 are nominally flush with end of drive.

Dimension Table

	Inches			Millimeters
A	5.75	±	.025	146.05	±	.64
B	4.00	±	.015	101.60	±	.38
C	1.620	+	.027	41.1	+ .69
		–	.21		– .53
D	2.362	±	.010	60.00	±	.25
E	1.120	±	.020	28.45	±	.51
F	4.000	±	.010	101.60	±	.25
G	.250	+	.010	6.35	+ .25
		–	.005		– .12
H	1.750	±	.010	44.45	±	.25
J	3.750	±	.010	95.25	±	.25
K	1.625	±	.020	41.28	±	.51
L	.143			3.63
M	.753			19.13
N	.165	[7]		4.19		[7]
P	.405			10.29
R	2.265			52.53
S	2.350			59.69

Figure 6. Mounting configuration dimensions