Seagate ST930218A Configuring and mounting the drive, Handling and static discharge precautions

Page 25

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive only by its edges or frame.

•The drive is fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

Momentus 4200.2 Product Manual, Rev. C

19

Image 25

Contents Momentus Page Contents Momentus 4200.2 Product Manual, Rev. C List of Figures Momentus 4200.2 Product Manual, Rev. C Momentus 4200.2 Pata disc drive IntroductionMomentus 4200.2 Product Manual, Rev. C Specification summary Drive specificationsSpecifications for 120, 100, and 80 GB models Drive specification ST9120824A ST9100825A ST980829AFollowing web Warranty Drive specification ST960812A ST950814A ST9402112A ST930218A Specifications for 60, 50, 40, and 30 GB modelsSpecifications for 60, 50, 40, and 30 GB models LBA mode Default logical geometryFormatted capacity Physical organizationTechnology Specification Physical characteristicsRecording and interface technology Seek timeTime to ready Power specificationsConducted noise Typical current profileVoltage tolerance Power management modes Power-management modesActive mode Idle modeEnvironmental specifications Operating shock ShockNonoperating shock VibrationElectromagnetic immunity AcousticsDrive level acoustics Electromagnetic immunityMeasurement type Specification Safety certificationReliability Agency certificationAustralian C-Tick N176 Korean RRLFCC verification Corrosive environment Environmental protectionEuropean Union Restriction of Hazardous Substances RoHS Momentus 4200.2 Product Manual, Rev. C Handling and static discharge precautions Configuring and mounting the driveMaster/slave configuration Jumper settingsCable-select option Drive mounting Mounting dimensions-top, side and end viewMomentus 4200.2 Product Manual, Rev. C Connector signals ATA interface signals and connector pinsConnector Cable Signal Name Contact Conductor Cable Connector Conductor Contact Signal NameSupported commands Supported ATA commandsCommand name Command code in hex ATA-standard commands ATA-standard power-management commands Command name Command code in hexATA-standard security commands Word Description Value Identify Device commandXxxxH Bit Word Description if bit is set to Bit WordFeatures register values Set Features commandMomentus 4200.2 Product Manual, Rev. C Compatibility summary Installation considerationsTested systems System CompatibilityTested Bios versions Bios versions testedVendor Release Revision Operating system versions tested Compatibility test configurationsSoftware utilities Other certificationInternet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index Page Page Momentus 4200.2 Product Manual, Rev. C Page Seagate Technology LLC