Seagate ST95005620AS manual Yes requires Comreset from host after a hotplug event

Table 1:	Drive specifications
Drive specification		ST95005620AS	ST93205620AS	ST92505610AS
Read power (watts typical)		2.4
Write power (watts typical)		2.3
Idle mode, low power (watts typical)		0.8
Standby mode (watts typical)		0.40 ***
Sleep mode (watts typical)		0.40 ***
Voltage tolerance (including noise)		+5V ± 5%
Ambient temperature (°C)		0 to 60 (operating)
		–40 to 70 (nonoperating)
Temperature gradient (°C per hour max)		20 (operating), 35 (nonoperating)
Relative humidity		5% to 95% (operating and nonoperating
Relative humidity gradient		30% per hour max
Wet bulb temperature (°C max)		37.7 (operating)
		40 (nonoperating)
Altitude, operating		–304.8 m to 3,048 m (–1000 ft to 10,000+ ft)
Altitude, nonoperating		–304.8 m to 12,192 m (–1000 ft to 40,000+ ft)
(meters below mean sea level, max)
Shock, operating (Gs max at 2 ms)		350
Shock, nonoperating (Gs max at 2 ms)		800
Shock, nonoperating (Gs max at 1 ms)		1000
Shock, nonoperating (Gs max at 0.5 ms)		600
Vibration, operating		1.0 G (0 to peak, 5–500 Hz)
Vibration, nonoperating		5 Gs (0 to peak, 5–500 Hz)
Drive acoustics, sound power (bels)
Idle**		2.3 (typical)
		2.5 (max)
Performance seek		2.6 (typical)
		2.7 (max)
Nonrecoverable read errors		1 per 1014 bits read
Annualized Failure Rate (AFR)		0.5%
Load/Unload (U/UL) cycles
25°C, 50% relative humidity		600,000 software-controlled power on/off cycles
		50,000 hard power on/off cycles
32°C, 80% relative humidity		600,000 software-controlled power on/off cycles
5°C, 80% relative humidity		50,000 hard power on/off cycles
5°C, 10% relative humidity
55°C, 16% relative humidity
Warranty		To determine the warranty for a specific drive, use a web browser to access the following
		web page: support.seagate.com/customer/warranty_validation.jsp
		You will be asked to provide the drive serial number, model number (or part number) and
		country of purchase. After submitting this information, the system will display the war-
		ranty information for your drive
Supports Hotplug operation per		Yes (requires COMRESET from host after a hotplug event)
Serial ATA Revision 2.6 specification

*One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.

**During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.

***Typical notebooks will pull power to the drive when entering S3 and S4; while in the S3 and S4 states, drive sleep and drive standby modes will not contribute to battery power consumption.

4 Momentus XT Product Manual, Rev. A