Seagate ST15150N/ND/DC, ST15150W/WD/WC manual Drive models, General information

Page 21

Barracuda 4 Installation Guide, Rev. E

19

Initial setup information

The general information beginning on this page applies to all of the Barracuda 4 models. After reading the general information topics, refer to the appropriate drive-specific section listed below for additional infor- mation about configuring and installing your particular model.

Drive models	Page
ST15150N/ND	35
ST15150W/WD	40
ST15150WC/DC	46

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Synchronizing spindles

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables

•Formatting the drive

Image 21

Contents Barracuda 4 Family ST15150N/ND/DC ST15150W/WD/WC Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Barracuda 4 Installation Guide, Rev. E Wichtige Sicherheitshinweise Barracuda 4 Installation Guide, Rev. E Page Barracuda 4 Installation Guide, Rev. E Page CompuServe Forum SeaFAX USA 408 438-2620 EnglandSeaFONE 408 SeaTDD 408SeaBOARD Location Number TelephoneGeneral description Barracuda 4 disc drive W/WD WD/WC/DC ND/WD/DC Barracuda 4 Installation Guide, Rev. E From previous General information Drive modelsScsi ID jumpers Scsi bus termination Drive terminationTerminator power Synchronizing spindles optionalOther applicable jumper options Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 5. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der Kabel Dimensions ST15150N/ND Abbildung 6. Laufwerkabmessungen Dimensions ST15150W/WD Abbildung 7. Laufwerkabmessungen Dimensions ST15150WC/DC Abbildung 8. Laufwerkabmessungen Page DC power connector Abbildung 9. Gleichstromanschluß Hinweis Formatting the drive Scsi Setting the Scsi ID jumpersTerminating the drive Terminating the driveDrivesN/ND Scsi Synchronizing spindlesSeveral other jumper options are available as illustrated DrivesW/WD WD drives Power Connector ST15150W/WD Pin DC Power Write Protect option WP Write Protect = On disables writing MTR DrivesWC/DC Connecting remote LEDs Jumper options Barracuda 4 Installation Guide, Rev. E Barracuda 4 Installation Guide, Rev. E