Barracuda 4 Installation Guide, Rev. E | 35 |
Setting the SCSI ID jumpers
Use the J4 connector to set the SCSI ID (Figure 10). To change the SCSI ID, install jumpers on the appropriate pins as shown in the illustration.
SCSI |
|
Connector |
|
DC Power |
|
Connector |
|
| Pin 1 |
| J4 |
| ID1 |
ID2 | ID0 |
Select SCSI ID by placing jumpers as shown below. J4
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
Figure 10. Setting the SCSI ID
N/ND drives