Seagate ST15150W/WD/WC, ST15150N/ND/DC manual Mounting the drive and connecting cables

Page 28

26

Barracuda 4 Installation Guide, Rev. E

Mounting the drive and connecting cables

Note. This mounting procedure does not apply to WC or DC model drives. To mount a WC or DC drive, plug the drive into the system's single connector attachment (SCA) position on the system's back panel.

Do not touch the connector pins or any components on the control board without observing static-discharge precautions. Always handle the drive by the frame only.

The drive may be mounted in any orientation (horizon- tally, vertically, and any combination thereof); however, you must ensure that the drive receives adequate air flow for cooling.

1.Mount the drive to the host system’s chassis using four 6-32 UNC screws. Two mounting holes are in each side of the drive and there are four mounting holes in the bottom of the drive. See Figures 6, 7 or 8.

The maximum length that the screws should ex- tend into the chassis mounting holes is 0.15 inch (3.81 mm), measured from the outer surface of the chassis. Tighten the screws down evenly. Do not over-tighten or force the screw if it does not seem to screw in easily, because this means the threads are not properly aligned. In this case, back the screw out and try again.

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Barracuda 4 Family ST15150N/ND/DC ST15150W/WD/WC Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page Barracuda 4 Installation Guide, Rev. E Wichtige Sicherheitshinweise Barracuda 4 Installation Guide, Rev. E Page Barracuda 4 Installation Guide, Rev. E Page SeaFAX USA 408 438-2620 England CompuServe ForumSeaTDD 408 SeaFONE 408SeaBOARD Telephone Location NumberGeneral description Barracuda 4 disc drive W/WD WD/WC/DC ND/WD/DC Barracuda 4 Installation Guide, Rev. E From previous Drive models General informationScsi ID jumpers Drive termination Scsi bus terminationSynchronizing spindles optional Terminator powerOther applicable jumper options Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 5. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der Kabel Dimensions ST15150N/ND Abbildung 6. Laufwerkabmessungen Dimensions ST15150W/WD Abbildung 7. Laufwerkabmessungen Dimensions ST15150WC/DC Abbildung 8. Laufwerkabmessungen Page DC power connector Abbildung 9. Gleichstromanschluß Hinweis Formatting the drive Setting the Scsi ID jumpers ScsiTerminating the drive Terminating the driveDrivesN/ND Synchronizing spindles ScsiSeveral other jumper options are available as illustrated DrivesW/WD WD drives Power Connector ST15150W/WD Pin DC Power Write Protect option WP Write Protect = On disables writing MTR DrivesWC/DC Connecting remote LEDs Jumper options Barracuda 4 Installation Guide, Rev. E Barracuda 4 Installation Guide, Rev. E
Top Page Image Contents