Seagate ST9500323CS, ST9320328CS manual Drive mounting, Top cover stiffness/deflection

Page 28

For installations which require cables, you can connect the drive as illustrated in Figure 2.

inter ace connector

ower connector

inter ace ca le

ower ca le

Figure 2. Attaching SATA cabling

Each cable is keyed to ensure correct orientation.

3.4Drive mounting

You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 3 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:

Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.

Use only M3 UNC mounting screws.

Do not overtighten the mounting screws. Maximum torque: 4.0 inch-lb. (0.4519 N-m).

Four (4) threads (0.080 inches, 2.032 mm) minimum screw engagement recommended.

Avoid excessive drive distortion when mounting. Refer to the following specifications for stiffness/deflection information:

Top cover stiffness/deflection

 

 

 

Operating with no performance degradation, emitted noise,

10 mm probe: 1.02kgf or

mechanical damage, or hard errors

5 mm probe: 0.92kgf

 

 

Non-operating with no hard errors

20 mm probe: 2kgf at any point of top cover

 

20 mm probe: 15kgf at top cover edges only

 

 

18

Pipeline HD Mini Series SATA Product Manual, Rev. E

Image 28
Contents Pipeline HD Mini Series Sata ST9500323CSST9250311CS ST9320328CSST91603110CSRevision history Revision Date Sheets affected or commentsPipeline HD Mini Series Sata Product Manual, Rev. E Pipeline HD Mini Series Sata Product Manual, Rev. E Contents Pipeline HD Mini Series Sata Product Manual, Rev. E List of Figures Page Seagate Technology Support Services Viii Introduction About the Serial ATA interfacePage Drive specifications Specification summary tableSleep mode Default logical geometry LBA modeFormatted capacity Cylinders Read/write heads Sectors per track 16,383Physical characteristics Physical organizationRecording and interface technology Seek timePower specifications Start/stop timesDC power Typical current profilePower-management modes Power management modesActive mode Idle modeEnvironmental specifications Acoustics Electromagnetic immunity Test for Prominent Discrete Tones PDTsRadio frequency environments Performance Reference Test Description Level StandardSafety certification ReliabilityAgency certification Annualized Failure Rate AFREnvironmental protection Korean RRLAustralian C-Tick N176 FCC verificationEuropean Union Restriction of Hazardous Substances RoHS Corrosive environmentChina Restriction of Hazardous Substances RoHS Directive Pipeline HD Mini Series Sata Product Manual, Rev. E Configuring and mounting the drive Handling and static-discharge precautionsConfiguring the drive Serial ATA cables and connectorsDrive mounting Top cover stiffness/deflectionMeasurements shown in are in inches Pipeline HD Mini Series Sata Product Manual, Rev. E Serial ATA connector pin definitions SignalSerial ATA Sata interface Segment Pin Function DefinitionPower Supported ATA commandsCommand name Command code in hex ATA-standard commands Command name Command code in hex ATA-standard power-management commands ATA-standard security commandsIdentify Device command Word Description ValueXxxxH Description if bit is set to Bit Word Bit WordSet Features command Set Features command valuesA.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Pipeline HD Mini Series Sata Product Manual, Rev. E Index ITE TPI Pipeline HD Mini Series Sata Product Manual, Rev. E Page Seagate Technology LLC