Seagate ST31270A manual Drive connectors

Page 8

6	Medalist 1270 Installation Guide, July 1995

J8. Options

jumper block

J8 pin 1

J1. Interface

connector

pin 1

J3. Standard

power connector

1	2	3	4	Circuit
				Circuit

board

+5V

+5V return

+12V return

+12V

Figure 1. Drive connectors

Image 8

Contents Medalist ATA Interface Drive Contents Introduction Drive features LBABefore you begin Sicherheitsanleitung Configuring the drive Required materialsDrive connectors Options jumper block settings Medalist 1270 Installation Guide, July Attach a power-supply cable to the drive Attaching the cablesMounting the drive Mounting holesTransferring the software from the drive Type format a /sMedalist 1270 Installation Guide, July Determining if your Bios accepts more than 528 Mbytes Solutions for surpassing the 528-Mbyte barrierConfiguring the computer Using the installation softwareMedalist 1270 Installation Guide, July Medalist 1270 Installation Guide, July Medalist 1270 Installation Guide, July Standard setup Dual-drive emulation installation Model Setup Mbytes Cyl Heads SectorsDual-drive emulation 024Partitioning Partitioning and formatting the driveLow-level formatting Windows 32-bit disk access High-level formattingMedalist 1270 Installation Guide, July Basic troubleshooting Advanced troubleshooting System does not recognize the driveMedalist 1270 Installation Guide, July Screen remains blank when you power up the system System error message, Drive not Ready, appearsDrive does not format to full capacity System error message, HDD controller failure appears Disabling EZ-DriveDisabling Maximum Overdrive Location Modem number Technical support servicesSeaBOARD SeaFAX Location Telephone numberSeagate Technical Support FAX /438-8137 SeaFONE /438-8222Seagate’s Internet connections Storing and shipping your drive Drive in an approved package