Seagate ST760211DE manual Mounting considerations, Lyrion Series Area for Protective Mounting

Page 28

3.3Mounting considerations

•Use an elastic mounting material to protect drives so as to ensure that more shock can be absorbed.

•There are guides along the side for mounting. Refer to figure on areas (refer to Figure 8, shaded area) where the mounting material can rest for mounting.

•As the drive is a sensitive device, it is not recommended to have any mounting force on the top and bottom surface of the drive other than the recommended mounting surfaces. Mounting force on non recommended surfaces shall not exceed 6.8N.”

•The drive can be operated in any orientation but horizontal or vertical orientation is preferred.

•Allow a minimum clearance of 0.012 inches (0.30 mm) around the entire perimeter of the drive for cooling, with the exception of the mounting edges for better airflow.

•In case the system design warrants bending of the FPC to the hard disc drive, care should be taken to maximize the radius.

•Mounting materials are available from many third-party vendors.

•The 40-way connector is design to meet minimum 6N Horizontal FPC retention after mating.

•The connector has a specification of 20 insertion cycles.

Note. Drive thickness (t) around Bumper Region with Screw	: 3.404 ±	0.200 mm
Drive thickness (t) around Bumper Region without Screw	: 3.308	± 0.200 mm

Figure 8. Lyrion Series Area for Protective Mounting

22	Lyrion Series IDE Product Manual, Rev. B

Image 28

Contents Lyrion Series IDE ST760211DE ST730212DERevision history Revision Date Sheets affected or commentsContents Lyrion Series IDE Product Manual, Rev. B List of Figures Lyrion Series IDE Product Manual, Rev. B Introduction Lyrion Series IDE interface disc driveDisclaimer Drive careDrive specifications SpecificationsDrive specification ST760211DE ST730212DE OverviewDefault logical geometry LBA mode addressingFormatted capacity Model Cylinders Heads SectorsPhysical characteristics Technology SpecificationRecording and interface technology Time to readyPower specifications Power Consumption at Average W DC powerTypical current profile Conducted noise Power-management modes Active modeStandby/Sleep mode Power modes Heads Spindle BufferEnvironmental specifications Shock Operating shockNonoperating shock VibrationOperating sweep sine vibration Operating random vibrationOperating random vibration profile Nonoperating sweep sine vibrationNonoperating random vibration profile Nonoperating random vibrationCorrosive environment Acoustics Electromagnetic immunityReliability Drive level acousticsSafety certification Agency certificationElectromagnetic compatibility Korean RRLChina Restriction of Hazardous Substances RoHS Directive FCC verificationPage Lyrion Series IDE Product Manual, Rev. B Configuring and mounting the drive Handling and static discharge precautionsPage Drive installation Lyrion Series mechanical dimensions-top, side and end viewMounting considerations Lyrion Series Area for Protective MountingConnector interface signals and connector pins 40-way ZIF IDE interface connector signalsPin number Signal Name Description Interface descriptionWay ZIF IDE interface connector signals Supported commands Supported ATA commandsCommand Name Command Op-Code Command Type Supported commands Identify Device command Word ATA specification ValueLyrion Series IDE Product Manual, Rev. B Xxxx Serial Number Set Features command Features register valuesTransfer mode Read look-aheadRegister default values Power On Reset Hardware Reset Software ResetLyrion Series IDE Product Manual, Rev. B Seagate Technology support services InternetPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Publication feedback survey Lyrion Series IDE Product Manual, Rev. B Index Page Page Seagate Technology LLC

Related manuals

Manual 44 pages 40.16 Kb