Mounting the drive and connecting cables

Elite 23 Installation Guide, Rev. A

Mounting the drive and connecting cables

Do not touch the connector pins or any components on the con- trol board without observing static-discharge precautions. Always handle the drive by the frame only.

The drive may be mounted in any orientation (horizontally, verti- cally, and any combination thereof); however, you must ensure that the drive receives adequate air flow for cooling.

1.Mount the drive to the host system’s chassis using four 6-32 UNC screws. Two mounting holes are in each side of the HDA and there are four mounting holes in the bottom of the HDA.

The maximum length that the screws should extend into the HDA mounting holes is 0.17 inch (4.318 mm), measured from the outer surface of the HDA. Tighten the screws down evenly. Do not over-tighten or force the screw if it does not seem to screw in easily, because this means the threads are not properly aligned. In this case, back the screw out and try again.

Installation des Laufwerkes und Anschluß der Kabel

Beachten Sie beim Handhaben und Anfassen der Anschlußstifte und Komponenten die Vorsichtsmaßnahmen zur Verhinderung statischer Aufladung. Fassen Sie das Laufwerk nur am Rahmen an.

Das Laufwerk kann in beliebiger Orientierung (horizontal, ver- tikal oder schräg) installiert werden;jedoch muß dafür gesorgt werden, daß ein ausreichender Luf tstrom zur Kühlung des Lauf- werkes vorhanden ist.