Seagate ST423451N/W/WD manual Setting terminator power jumpers on W models

Page 42
Pin 1

40

Elite 23 Installation Guide, Rev. A

W/WD drives

Terminator power

There are three possible terminator power configurations for ST423451W drives (see Figure 13). You will not normally need to change this option and can leave the drive configured as it was shipped from the factory.

There are two possible terminator power configurations for ST423451WD drives (see Figure 13).

Pin 2

Pin 1Pin 4

Pin 3

J01

Pin 2

J01

Terminator Power Option (TP)

Internal terminator power source.

External terminator power source.

Internal terminator and drive power to I/O.

 

Pos. B

Pos. A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Pin 4

Pos. 2

Pos. 1

Pin 3

Figure 13. Setting terminator power jumpers on W models

Image 42
Contents Elite Disc Drive ST423451N/W/WD Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page Wichtige Sicherheitshinweise Page European Union Compliance Page Seagate Technology Online services SeaFONE at 1-800-SEAGATESeaNET SeaBOARD BBS Location Modem numberSeagate Technology Forum on CompuServe Location Telephone number Seagate Technology FAX servicesSeaFAX Seagate technical support FAXSeagate technical support line SeaTDDGeneral description Drive characteristics Elite 23 Installation Guide, Rev. a Dimensions of the drive Drive models General informationScsi ID jumpers Drive termination Terminator power Circuits and data path widthsCable characteristics for single-ended circuits Fifty-pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelElite 23 Installation Guide, Rev. a Pin Power Pin GleichstromHinweis Page Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on N modelsTerminating the drive Terminating the driveSetting terminator power jumpers on N models Other applicable jumper options Additional jumper optionsWD drives Terminating the drive ST423451W shown Setting terminator power jumpers on W models Other option jumpers are available as illustrated below Active, Ready, and Fault indicators LED indicator connections for all drive modelsPage Page