Seagate ST3750840ACE manual Configuring and mounting the drive

Page 27

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

DB35.3 Series PATA Product Manual, Rev. B

21

Image 27

Contents DB35.3 Series Pata Page Contents DB35.3 Series Pata Product Manual, Rev. B List of Figures DB35.3 Series Pata Product Manual, Rev. B Introduction DB35.3 Series Pata Product Manual, Rev. B Specification summary table Drive specificationsDrive specification ST3750840ACE ST3500830ACE ST3400820ACE DB35.3 Series Pata Product Manual, Rev. B Drive specification ST3320820ACE ST3300820ACE ST3250820ACE DB35.3 Series Pata Product Manual, Rev. B Cylinders Read/write heads Sectors per track 16,383 Default logical geometryLBA mode Formatted capacity750GB 500GB 400GB 320GB 300GB 250GB Physical characteristicsDrive specification Recording and interface technologyPower specifications Seek timeStart/stop times DC power requirements Standby modeConducted noise Typical current profileSleep mode Power-management modesActive mode Idle modeEnvironmental specifications 4 Disc models ShockOperating shock Nonoperating shock Disc modelsAcoustics Fluid Dynamic Bearing FDB motor acousticsIdle CE seek profile Agency certification Safety certificationElectromagnetic immunity ReliabilityFCC verification Electromagnetic compatibilityKorean RRL Australian C-Tick N176Environmental protection Corrosive environmentEuropean Union Restriction of Hazardous Substances RoHS DB35.3 Series Pata Product Manual, Rev. B Handling and static discharge precautions Configuring and mounting the driveBreather filter hole location Breather filter hole precautionsCable-select option Jumper settingsMaster/slave configuration Drive as master with a non-ATA-compatible slaveUltra ATA/100 cable Drive mountingMounting dimensions-top, side and end view DB35.3 Series Pata Product Manual, Rev. B ATA interface signals and connector pins Pins and supported ATA signalsATA interface Command name Command code in hex Supported ATA commandsF4H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit Word0CH Set Features commandCode in features Register A.R.T. command 4 S.M.A.R.T. commandsTechnical Support Seagate Technology support servicesInternet Presales SupportWarranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dial Index Page TMR DB35.3 Series Pata Product Manual, Rev. B Page Seagate Technology LLC

Related manuals

Manual 52 pages 3.56 Kb