Tyco Electronics 17A2 manual Wireless Card, TV Tuner Card

Page 55

Wireless Card

The wireless card can be selected to provide wireless capabilities. All touchcomputers are "Wireless Ready" and are pre-wired with wireless antennas inside the chassis Typical specifications are as follows for the wireless card:

•MiniPCI interface

•Compliant to MiniPCI industry standard sizing

•802.11b/g compliant

•Two (2) UFL connectors

•Support for Windows 2000, Windows XP and Windows Vista 32

•RoHS Compliant

TV Tuner Card

A TV tuner card may be selected to be installed in the touchcomputer to provide digital TV tuner capabilities. All touchcomputers are "TV Ready" and are pre-wired with coaxial connectors inside the chassis. The minimum specifications are as follows for the TV tuner card:

•MiniPCI interface

•Compliant to MiniPCI industry standard sizing

•ATSC version supports ATSC/NTSC/PAL/SECAM with F connector input

•DVB-T version supports DVT-B/NTSC/PAL/SECAM with TV aerial connector input

•RF input

•Support for Windows 2000, Windows XP and Windows Vista

•RoHS compliant

Note: Only one MiniPCI interface is available. Concurrent use of wireless and TV- Tuner is not feasible.

Elo TouchSystems 17A2 User Guide 55

Image 55

Contents Touchcomputer User Guide LCD Multifunction Touchcomputer Elo TouchSystems Touchcomputer User GuideRevision D E926979 Elo TouchSystems Disclaimer Copyright c 2008 Tyco Electronics. All Rights ReservedTable of Contents Technical Support Unpacking Your Touchcomputer SetupFront View Rear View Product OverviewSide View Base Bottom View Display Orientation Display Orientation with Peripherals Language Selection Initial Turn-OnPage Time-zone selection Test Devices Testing the TouchscreenCalibration Testing in USB MSR Keyboard KB Emulation Mode Testing the Magnetic Stripe Reader MSR optionalTesting in USB MSR Human Interface Device HID Mode Converting MSR from Keyboard Emulation to HID and vice versa Testing the Customer Display optional Testing the Finger Print Reader optional Testing the Barcode Scanner optional Page Enabling 2-D Scanning Testing the DVD Drive optional Testing the Speaker Bar optionalChanging DVD region Testing the TV tuner optional Testing the Wireless Card optionalTesting the Cash Drawer Port Operation OSD Menu OSD ControlTo unlock the OSD OSD LockoutShortcut keys To lock the OSDTo lock the Power Power ControlPower Button Power LockoutUsing the I/O panel TV Tuner optional PS/2 UniversalKensingtonTM Lock Mount as shown Securing the Touchcomputer BaseMounting Option Snap off stand coverMounting Option Display Angle Adding Peripherals UpgradesMaintenance Waste Electrical and Electronic Equipment Weee Directive Care and Handling of Your TouchcomputerServicing the Hard Disk Drive and Compact Flash Card To Install the Hard Disk DriveTo Install the Compact Flash Card Recovering the Operating SystemTechnical Specifications RAM Touchcomputer SpecificationsPage RS422 Mode Pin Definitionfor COM2 only COM1, COM2 ConnectorRS232 ModeRS485 Mode Pin Definitionfor COM2 only DB9 connector Pin Definition RJ45 connector Pin DefinitionPower Input Pin Definition Control Cash Drawer Port Signal Definition and ControlPage Page Display Specifications Power Supply Specifications Touchscreen Specifications USB Version Peripherals SpecificationsMagnetic Stripe Reader MSR Customer DisplayFingerprint Reader Barcode Scanner One-Dimensional scanner specificationsOmni-Directional scanner Elo P/N E787026 specifications USB-SSI converter board Elo P/N E580321 specificationsSpeaker Bar DVD Drive TV Tuner Card Wireless CardAltitude Environmental SpecificationsTemperature Ranges HumidityTechnical Assistance Using the TouchcomputerUsing the Web Using the Phone Technical SupportRegulatory Information Electrical Safety InformationII. Emissions and Immunity Information Page III. Safety Label Warranty Page Check out Elo’s Website