Tyan Computer B2933 manual Installing a 2.5 Hard Drive rear location

Page 44

2.3.2Installing a 2.5” Hard Drive (rear location)

1.Remove the screw securing the 2.5” drive bracket in the GT14 chassis.

2.Slide the drive tray out (A) and lift the bracket out from the chassis (B).

3. Place a 2.5” hard drive into the drive bracket.

36	Chapter 2: Setting Up

Image 44

Contents Transport GT14 B2933 Service Engineer’s Manual Page Preface Federal Communications Commission FCC About this Manual Safety Information Table of Contents Replacing Pre-Installed Components About the Transport GT14 B2933 Product ModelFeatures EnclosureBios Unpacking Rail for 4-post rack Rail for 2-post rackRail for 4-post rack Rear View About the ProductFront View LED Definition Front Panel Rear I/O LEDInternal View Motherboard Socket FMotherboard Layout Jumpers & Connectors Jumper Function ConnectorFRU List Model Picture Quantity Description Number Standard PartsModel Picture Quantity Description Number Model Picture Quantity Description Number Optional Parts Model Picture Quantity Description Tools Before You BeginWork Area Precautions Installing Motherboard Components Removing the Top Chassis CoverInstalling the CPU and Heatsink Setting Up Installing the Memory Setting Up Population order for 64-bit mode is DIMM3 first, then DIMM1 Installing the PCI-E Card Setting Up Installing the 3.5 Hard Drive Installing a 3.5 Hard Drive front locationSetting Up Setting Up Installing a 3.5 Hard Drive rear location Setting Up Setting Up Installing the 2.5 Hard Drive Installing a 2.5 Hard Drive front locationSetting Up Setting Up Installing a 2.5 Hard Drive rear location Setting Up Connect the Sata drive data and power connectors Installing Dual 2.5 Hard Drives Option Installing Dual 2.5 Hard Drives front locationSetting Up Setting Up Setting Up Setting Up Installing Dual 2.5 Hard Drives rear location Setting Up Setting Up Rack Mounting Screws ListInstalling the Server in a Rack with Rail kit a Installing the Inner Rails to ChassisSetting Up Installing Outer Rails to the Rack Rackmounting the Server Setting Up Installing the Server in an Open Rack with Rail kit B Setting Up Setting Up LCD Software Setup Configuring the SystemLCD Console Key DefinitionDOS Mode and Windows Mode DOS ModeSystem Nics Windows ModeHost Name Power Ctrl System SensorsLinux Mode Screen Display Replacing Pre-Installed Components IntroductionPrecautions Disassembly Flowchart Following flowchart outlines the disassembly procedureRemoving the Top Chassis Cover Disconnecting All Motherboard Cables Replacing Motherboard ComponentsRemoving the Motherboard Replacing the LCD Module and LED Board Replacing Pre-Installed Components Replacing Pre-Installed Components 1 M1017 LED Board Features 2 M1017 LED Board Connector Pin DefinitionReplacing the USB Board USB Board Features USB Board Connector Pin DefinitionReplacing the Cooling Fans Replacing Pre-Installed Components Replacing the Power Supply Replacing Pre-Installed Components Appendix I Bios Differences S2933 Advanced/Hardware Health ConfigurationB2933 Advanced/Hardware Health Configuration Advanced Bios Setup UtilityAppendix II Cable Connection Tables Other Cables Appendix III Installing the Smdc Card Cable Connection Table Appendix IV Installing the M2061 Riser Card Page Technical Support Help ResourcesReturning Merchandise for Service