Chapter 3
BIOS Configuration
Setting Option | BIOS Default | Setup Default | |
VGA |
| OFF | OFF |
LPT & COM | LPT / COM | LPT / COM | |
HDD & FDD | ON | ON | |
|
|
| |
DMA/master | OFF | OFF | |
Modem Ring Resume | Disabled | Disabled | |
|
|
| |
RTC Alarm Resume | Disabled | Disabled | |
Wake Up on LAN | Disabled | Disabled | |
|
|
| |
Primary INTR | ON | ON | |
IRQ3 (COM2) | Primary | Primary | |
IRQ4 (COM1) | Primary | Primary | |
|
|
|
|
IRQ5 | (Free) | Primary | Primary |
IRQ6 | (Floppy Disk) | Primary | Primary |
|
|
| |
IRQ7 (LPT1) | Primary | Primary | |
IRQ8 (RTC Alarm) | Disabled | Disabled | |
|
|
| |
IRQ9 (Free) | Secondary | Secondary | |
IRQ10 (Free) | Secondary | Secondary | |
IRQ11 (Free) | Secondary | Secondary | |
|
|
| |
IRQ12 (PS/2 Mouse) | Primary | Primary | |
IRQ13 (Coprocessor) | Disabled | Primary | |
|
|
| |
IRQ14 (Primary IDE) | Primary | Primary | |
IRQ15 (Secondary IDE) | Disabled | Disabled | |
|
|
|
|
Power Management
This option allows you to select the type (or degree) of power saving for Doze, Standby, and Suspend modes. See the section PM Timers for a brief descrip- tion of each mode. This table describes each power management mode:
Max saving | Maximum power savings. Only available for SL CPUs. | |
Inactivity period is 1 minute in each mode. | ||
| ||
|
| |
User Define | Set each mode individually. Select | |
Timers section, following. | ||
| ||
|
| |
Min Saving | Minimum power savings. Inactivity period is 1 hour in each | |
mode (except the hard drive). | ||
| ||
|
|
Power Saving Function
This function allows your system to reduce power consumption when it is idle.
PM Control by APM
If Advanced Power Management (APM) is installed on your system, selecting Yes gives better power savings.
http://www.tyan.com
50