
Super IO Device:
Phoenix – AwardBIOS CMOS Setup Utility
Super IO Device
  | 
  | 
  | 
  | 
Onboard FDC Controller  | [Enabled]  | 
  | Item Help  | 
Onboard Serial Port 1  | [3F8 / IRQ4]  | _________________________  | |
Onboard Serial Port 2  | [2F8 / IRQ3]  | 
  | |
UART Mode Select  | [Normal]  | Menu Level ►►  | |
RxD, TxD Active  | [Hi, Lo]  | 
  | |
IR Transmission Delay  | [Enabled]  | 
  | |
UR2 Duplex Mode  | [Half]  | 
  | |
Use IR Pins  | 
  | ||
Onboard Parallel Port  | [378 / IRQ7]  | 
  | |
Parallel Port Mode  | [SPP] | 
  | |
EPP Mode Select  | [EPP1.7]  | 
  | |
ECP Mode Use DMA  | [3]  | 
  | 
  | 
Game Port Address  | [201]  | 
  | 
  | 
Midi Port Address  | [330]  | 
  | 
  | 
Midi Port IRQ  | [10]  | 
  | 
  | 
↑↓←→: Move Enter: Select 
F5: Previous Values F6: 
Onboard FDC Controller:
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install 
Enabled / Disabled
Onboard Serial Port 1 / 2:
Select an address and corresponding interrupt for the first and second serial ports.
3F8/IRQ4 / 2E8/IRQ3 / 3E8/IRQ4 / 2F8/IRQ3 / Disabled / Auto
UART Mode Select:
This field allows the users to configure what IR mode the 2nd serial port should use. Normal / IrDA and ASKIR
RxD, TxD Active:
This field configures the receive and transmit signals generated from the IR port. Hi, Hi / Hi, Lo / Lo, Hi / Lo, Lo
IR Transmission Delay:
This item allows you to “Enabled” or Disabled” the IR transmission delay.
Enabled / Disabled
UR2 Duplex Mode:
This item allows you to select IR “Half” or “Full” duplex function.
42
http://www.TYAN.com