Tut Systems XL-12000S manual Login Display, User Login

Page 38

XL-12000S

MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE

Figure 7.7 Serial Session/Version ID Screen

The section continues by describing how to initially configure the modem via the Console port.

7.2.3.2 Login Display

User Login

At the Login Display the User Login field is presented. The user login refers to a class of user.

Note: “Craft” is the only available user login and is displayed during login.

The system login time is one minute. If this time is exceeded, before keyboard activity begins, the session will be closed. The message “Login time exceeded” will be displayed and you will have to press <Enter> to connect to the XL-12000S. If you were connected via a Telnet session you will have to reconnect.

New XL-12000S modems are not password protected until you assign a password. Instructions for changing your password will be provided later in this manual (section 7.2.3.7). Attempting to enter a password will generate a “Password incorrect” error message. At this

30 TUT SYSTEMS

7.0 CONFIGURE THE MODEM

Image 38
Contents XL-12000S Print Warranty Policy Warranty SummaryIi TUT Systems Table of Contents Figures Tables Vi TUT Systems XL-12000S Product Overview Technical Specifications What’s in the Box DescriptionInstallation RJ-45 10Base-T Straight-through CableInstallation TUT Systems 10Base-T Cable Power LED Panel Indicators and ConnectorsFront Panel Indicators Activity LEDsTUT Systems Panel Indicators and Connectors Console Port Rear Panel Indicators and Connectors10Base-T Link LED Power and Boot Up Sequence Configure the Modem Quick StartTUT Systems Configure the Modem Serial Session/Version ID Screen Detailed Procedures Choosing the Appropriate Bridging/ Routing OptionAdministration Building Basic BridgingFor Modem Bridging Example Two Advanced Bridging Bridging Example Two Advanced BridgingBack to Table of Contents For Modem Routing Example One Using a Router and Bridge Combination IP Routing OnlyFor Modem 2 Bridge Routing Example Two Using a Router and Router Combination For Modem Bridge Non-IPConfiguration used for the modems in Bridge Non-IP example Block Packets Cursor Movement and Data Entry User Interface Keyboard CommandsNavigation Between Screens XL-12000S Keyboard Commands KEY DescriptionProcedures for Initial Configuration HyperTerminalConfigure the Modem TUT Systems Login Display User LoginFailed Login Attempts Login Display ScreenMain Menu Display Modem Management10 Modem Management Screen Field Description Telnet Setup Modem Configuration11 Modem Configuration Screen Configure the Modem TUT Systems Remote management session to the modem Password 12 Password Change ScreenSpecific field information for the Password Change Screen Advanced Modem Features Snmp ManagementTUT Systems Advanced Modem Features Modem Dhcp Relay Agent Dhcp Relay Agent ScreenUpgrade Software From the Main Menu select DTo install a new version Detailed Steps for Running Tutxlutil Tutxlutil /f upgrade-file /u username /p password target Modem Statistics Modem StatusModem Statistics TUT Systems Modem IP Packet Statistics Press Ctrl-X to return to the Main Menu Troubleshooting Troubleshooting TUT Systems Cannot Telnet to the modem Snmp cannot locate the modem No host named target was found Technical Support Equipment Return and Repair Maintenance and RepairTechnical Assistance and Customer Support Appendix a Pinout Assignments Appendix B Reference Screen Shots TUT Systems Appendix B Reference Screen Shots 11 Modem Configuration Screen Snmp Management Screen Upgrade Software Screen Modem IP Packet Statistics Screen Measuring Phone Wire Appendix C Measure Line LengthAppendix D Subnet Mask Table Appendix D Subnet Mask Table TUT Systems 232 Page TUT Systems