UNICOM Electric DynaGST/1602G user manual Rear Panel, LED Indicators

[Note] When the Mini GBIC module is installed, the Mini GBIC (Gigabit fiber) ports have higher priority than the Gigabit copper ports and supercede them. It doesn’t matter if the Gigabit copper port is connected before or after the Mini GBIC port is connected. The Mini GBIC port always has higher priority for connection. When the Mini GBIC port is connected, the Gigabit copper ports are disabled.

Rear Panel

The 3-pronged power plug, on/off switch, and Ventilation fan are located at the rear Panel of the DynaGST/1602G Gigabit Ethernet switch as shown in Figure 2-2. The Switch will work with AC in the range 100-240V AC, 50- 60Hz.

Figure 2-2. Rear panel of the DynaGST/1602G Gigabit Ethernet switch

LED Indicators

The LED Indicators give a real-time indication of system operating status. There are three LED-indicators (1000, LNK/ACT, FDX/COL) for each Gigabit port and one Power LED for the entire unit. The following table provides descriptions of LED status.

5