UNIMAX Houseware KVM Switch operation manual Up arrow

NTI UNIMUX MULTI-USER KVM SWITCH

An arrow to the left of a port number in the list indicates
the port the user is currently connected to. From
left to right, the columns display the following:		Cursor
•	Port Number
•	Port Name	Port Number
•	Power Status of the CPU (ON/OFF)	Port Name

Note: “NAC” indicates a non-accessible computer for that user

•The actual user number (1-8) connected to the CPU.

•If no user is connected to a CPU, the user number is replaced by a "–" (dash).

•If more than one user is connected to the same port, this field will indicate the total number of users connected and the text color will be red.

User

Power

Status

Scroll Bar

Menu

Items

Figure 9- Command Mode main menu-User

Note: While in Command Mode, the numbers on the NUM PAD on the keyboard are not active. If numbers are required while in Command Mode, use the numbers on the main key bank.

The list below describes the command functions available from the keyboard within the OSD mode of control after entering into Command Mode:

Function	Keystroke
Select the previous port	up arrow
Select the next port	down arrow
Go to specific port- Press any valid number from 1-	port # - Enter
1024 to connect to a desired port.
Increases the ports listed by 1 page	Page Down
Decreases the ports listed by 1 page	Page Up
Enter “Change Settings” menu	T
Toggle ports listed to view by port number or	O (letter, not
alphabetically by port name	number)
Enable/disable Scan Mode	S
Enable/disable Broadcast Mode	B
Enable/disable Sharing	H
(only available if the Administrator is logged in or if
security is disabled)
Enter Administrator menu	A
(only available if the Administrator is logged in)
Select the first port on the switch	Home
Select the last port on the switch	End
Display Help menu	F1
Global Help- display window navigation tips used	F2
throughout all menus
Display port information- when pressed, a window	F3
displays the port name and its position in the
configuration structure by level and port number
Update configuration- use to update the information	F5
describing the structure of the cascaded switches.
Use if a slave is powered-ON or OFF at any time after
initial startup

Note: The user must exit Command Mode to type to a CPU.

To exit Command Mode press <Esc> on the keyboard.

13