Cable Connections

NTI UNIMUX MULTI-USER KVM SWITCH

	USER 1			USER 2		USER 3	USER 4

	USER PORT			USER PORT		USER PORT	USER PORT
	UNIMUX-1X4			UNIMUX-1X4		UNIMUX-1X4	UNIMUX-1X4
	MASTER			MASTER		MASTER	MASTER
	CPU PORTS			CPU PORTS		CPU PORTS	CPU PORTS
				(TO USER PORT 2 ON		(TO USER PORT 3 ON	(TO USER PORT 4 ON
				SLAVES 1-4)		SLAVES 1-4)	SLAVES 1-4)
					USBVEXT-xx-MM		USBVEXT-xx-MM
USBVEXT-xx-MM		USBVEXT-xx-MM			USBVEXT-xx-MM
USBVEXT-xx-MM		USBVEXT-xx-MM
(USER			(USER			(USER	(USER
PORT 1)			PORT 1)			PORT 1)	PORT 1)

USER PORTS	USER PORTS	USER PORTS
UNIMUX-4X8	UNIMUX-4X8	UNIMUX-4X8
SLAVE	SLAVE	SLAVE
CPU PORTS	CPU PORTS	CPU PORTS
USBVEXT-xx-MM	USBVEXT-xx-MM	USBVEXT-xx-MM
(8 CABLES)	(8 CABLES)	(8 CABLES)

Users 5-8 only have access to CPUs 25-40. Users 1-4 have access to all CPUs

USER 5 USER 6 USER 7 USER 8

USER PORTS

UNIMUX-8X16

SLAVE

CPU PORTS

USBVEXT-xx-MM (16 CABLES)

CPU1

CPU 8

CPU9

CPU 16

CPU17

CPU 24

CPU 25

CPU 40

Figure 37- Cascaded configuration with single-user masters

The same cable used to connect a CPU to the UNIMUX is used to connect two UNIMUX switches together- USBVEXT-xx-MM. No other cables will be necessary. To connect a slave to a master

1.Connect the USB-A-male end of the USBVEXT-xx-MM to the USER 1 port on the slave.

2.Connect the 15HD male at the same end of the USBVEXT-xx-MM cable to the MONITOR 1 port on the slave.

3.Connect the USB-B-male end of the USBVEXT-xx-MM to the CPU 1 port on the master.

4.Connect the 15HD male at the same end of the USBVEXT-xx-MM to the VIDEO 1 port on the master.

Repeat this procedure for each USER and MONITOR port on the slave that is desired to be controlled through the master. Any USER and MONITOR ports that do not get connected to the master can be connected to by users. Users connected to a slave downstream from the master will control only the CPUs directly connected to that slave switch (i.e. users 5 and 6 in Figure 37 can only control CPUs 25-40).