QSC Audio DCM 30D, DCM 10D user manual If theater audio is distorted

Page 21

Troubleshooting (continued)

If theater audio is distorted ...

• Verify that the DCM Input Clip LED is not lit. If it is, the cinema processor output signal needs to be turned down.

•If any of the amplifier CLIP warning LEDs are illuminating, the output level of the DCM must be reduced or amplifier input sensi- tivity must be reduced.

-DCM output level is adjusted using the DCM Manager software. Determine which channel’s amplifier is clipping and make the necessary gain adjustments. This is done in the Speaker Properties pages. These gain settings compensate for driver sensitivity differences, so all the high and low (or high, mid, low) gains should remain the same number of dB apart (com- pared to their factory setting).

-Amplifier input sensitivity adjustment: Refer to amplifier owner’s manual.

If switching the BYPASS to EMERGENCY does not restore sound to the center channel...

Verify the DCM is receiving input signals from the Cinema Processor.

Verify connections from the Cinema Processor to the DCM.

Verify connections from the DCM to the center channel amplifier.

Verify the Cinema Processor and center channel amplifier are ON and functioning.

Verify the center channel amplifier’s Gain controls are set to a usable level.

Verify center channel amplifier loudspeaker connections and loudspeaker condition.

NOTE: If the DCM unit is okay, place the Bypass button back to the NORMAL position and the Load Fault indicator will light (after a few minutes) if there was an open- or short-circuit in the loudspeaker cables.

If the DCM fails to turn on when the Power switch is set to the “on” position....

Check the AC power cord and ensure both ends are fully inserted in their respective sockets.

Check that the AC circuit being used is functioning. Test with a lamp or other known-good device.

Image 21
Contents TD-000265-00 Important Safety Instructions & Explanation of symbols Federal Communications Commission FCC Information Unpacking IntroductionProjectionist Features Installer FeaturesSystem Concepts Provides Monitor and Crossover functions in one boxMonitor source selector buttons Monitor volume control Power switchIllustrations- Front Panels DCM 10/10DIllustrations- Rear Panels Front Panel Hardware DescriptionHardware Description Rear Panel DCM 30 DataPort IllustrationTion, input is from the Digital Input DCM 30/30D Rack Mounting MountingSupporting the Rear of the DCM Attaching Rear Rack Ears MethodUsing the DCM Manager Software Software InstallationSoftware Description DCM Manager Windows SoftwareConnections Required CablesAC Mains Pin # Signal Description Configuration 15-pin SubD high-density male to 15-pinDataPort DataPort PinoutSurround EX Input Option Card Pinout Main Analog Input PinoutHearing Impaired Digital Input PinoutOutput Level 11.8 dBu Ohms MVrms ±5%Powered Subwoofer External Speaker ConnectionAuxiliary Input Connection System Calibration Troubleshooting If no sound in the theaterIf one audio channel is missing If theater audio is distorted Specifications Weight DimensionsSafety Agency Approvals ConnectorsHow to Contact QSC Audio Products Warranty InformationProduct Warranty